3D Fox Pro, Printer Controller 1.4.15
You'll be able to download in 5 seconds.
ABOUT 3D Fox Pro, Printer Controller
Print G-code files directly from your Android device via Wifi, Bluetooth or USB OTG/Host port. 3D Fox is simple to use, has a clear and meaningful log screen and works great on small/inexpensive devices as well. Developed with a Reprap Prusa i3 with Mega2560+Ramps+Marlin+Slic3r, Wifi module ESP8266 and BT module JY-MCU, it should work with many other HW/SW combinations. IMPORTANT: • Before buying this version please download the Free version and make sure your device and printer are supported, and that your are happy with the app. SPECIAL FEATURES: • Web interface to upload and print files from your PC/Tablet browser over the network. • Take back control of SD card printing jobs after losing connection with the printer. You can use this feature to manager several printers with the same device: start a print job on printer A, then do something else on printer B, finally go back to printer A and take back control of the pending printing job. NOTES: • You must put your G-code files in 3DFox directory of your Andorid device. Use a file manager (we recommend ES File Explorer) to move files from their original location to 3DFox • 3D Fox does not work with MakerBot or other printers using a proprietary communication protocol. USB CONNECTION • Android device must have a USB OTG/Host port: http://en.wikipedia.org/wiki/USB_On-The-Go • Supported printer USB-to-serial chips: - CDC ACM (eg Arduino Mega) - FTDI (eg Melzi, Sanguinololu) - CH34x - CP210X, PL2303 WIFI MODULE ESP-01 (ESP8266 chip) succesfully tested: • Firmware: transparent bridge 'esp-link' by JeeLabs: http://github.com/jeelabs/esp-link • Baud rate: 250000. • Upload speed: 1 MB transferred in 100 s (with Mega2560+Marlin), comparable to USB connection speed. • Antenna: performances boosted with this improvement: http://www.thingiverse.com/thing:1665680 BLUETOOTH MODULE • Bluetooth module JY-MCU connection and configuration: http://reprap.org/mediawiki/index.php?title=Jy-mcu#A_simple_way_to_change_BT_module_settings_-_apparently_using_ftdi_chip.2C_but_not_recommended SUPPORT: • For questions or bug reporting do not hesitate to write to [email protected].